Tipa

Special fountain pen - brush pen flux - for application of fluxes, solder liquids, fluxes, oils and paints in electronics in production and service, in mechanical assembly and in design

great advantage - easy refilling, like a classic fountain pen!

Using Flux pen
    it is dosed with a slight, adequate compression of the pen body
    the liquid is then applied to the site using a fine-fiber tip to prevent sticking
    it is perfectly used in hard-to-reach places and small details during spot application
    the tip of the pen has optimal stiffness and shape for these operations
    in electronics and mechanical assembly it ensures optimal accurate dosing of solder liquids, fluxes, fluxes, cleaners, oils
    greatly facilitates SMD and Fine Pitch soldering
    suitable for the application of water-soluble dyes and water-based inks when drawing

Do not use toluene or other aromatic liquids, acetone, etc. It resists water, ethyl alcohol, isopropyl alcohol (IPA) fluids and is not problematic.

Instructions for filling the Flux pen
    unscrew the upper pen tray
    press the magazine on the "PUSH" label and dip the bottom into the container with the appropriate solder liquid, flux ...
    relieve pressure on "PUSH", liquid is drawn into the reservoir
    Pull the reservoir out of the liquid and wipe it with a cloth if necessary
    screw the magazine into the second, lower part
    You can adjust the amount of liquid in the tip by gently pressing the tray
    After use, attach the protective cap to the tip

Materials used to make the pen
    magazine - PE
    brush - PBT
    cap - PP
    inner seal - PP
    holder - ABS
    sponge - PU
    nylon