Tipa

Surface disinfection is a liquid preparation intended for rapid disinfection of small areas and surfaces by wiping or spraying. Spectrum of product efficacy: bactericidal, virucidal, fungicidal.

Instructions for use:

It does not dilute. Application - spread with a disposable cloth, or apply with a sprayer. Wet the surface thoroughly with the solution and leave it to act for min. 5 minutes (exposure). Excess solution can be wiped off with a disposable cloth after the exposure time has elapsed.

Application:

- Apply to the surface of the disinfected surface so that it is completely wetted
- Leave on for at least five minutes
- After this time, wipe off excess product or wash with water
- In case of disinfection of floors or large areas, it is suitable to spray the product on disinfected ones
- place and then after five minutes wipe with warm water or allow to dry. It depends on the type of floor surface.
- The product is an application solution and is not intended for further dilution, eg as dosing into a wiping bucket
- FungiTOL is a chlorine-free product suitable for all surfaces. Surfaces should be free of visible dirt or greasy stains before application of the product.
- Do not spray the product into electrical installations and electronics, there is a risk of short circuits and subsequent ignition!
- Effectiveness of exposure standard (min.)
- Virucidal efficacy under low conditions
- Pollution against enveloped viruses VACV and BVDV ČSN EN 14476 + A1: 2015 5
- Bactericidal effect - low pollution ČSN EN 13697 5
- Fungicidal effect - low pollution ČSN EN 13697 15