Tipa

The Solarfam SZ-150-36MF photovoltaic panel is made of monocrystalline silicon. It is light and partially flexible and is designed primarily for mounting on slightly rounded surfaces, e.g. on boats or caravans. It is equipped with 90 cm long cables with MC4 terminals. It is designed for a system voltage of 12V.


Product parameters:

Description of the monocrystalline cell:
- for the production of a monocrystalline cell, a uniform quartz crystal ingot must be produced. Such production is quite demanding. The round ingot cuts to the so-called wafers that are cut to the required size of the PV cell. Because the ingot formed as one large crystal of silicon, its structure is uniform and very pure.

Advantages of a single crystal:
- greater efficiency of cells and higher yield of power from the same area
- slightly slower "aging" of silicon, ie. panel performance decreases more slowly over time
- cell staining is homogeneous, panels are not "spotty"


Technical parameters:

- model: SOLARFAM SZ-150–36MF (36 cells)
- max. no-load voltage Voc = 25.35V
- max. short-circuit current Isc = 7.51A
- max. voltage at 150W power: Vmp = 21.45V
- max. current at 150W power: Imp = 6.99A
- efficiency 19.27%
- working temperature: -40 ° C to + 85 ° C
- max. system voltage: 1000V
- dimensions: 1240 × 670 × 3mm / 4.5kg


Assembly:
- in the case of gluing a flexible panel to the roof of a vehicle, caravan, etc. it is necessary to take into account the different expansions of the roof and panel material, which can cause damage to the flexible panel.
- we recommend gluing flexible panels to an intermediate layer made of "Makrolon Plaxiglas" material, which also allows air to flow under the solar panel, thus increasing its efficiency.

Note: the flexible panel can only be bent on the longer side at a maximum angle of 25 °.