Tipa

Practical LED wall light with PIR sensor, solar panel and Li-Ion cell 18650 3.7V/1200mAh. Ideal for placement in outdoor spaces that are to be lit for safe passage.


Product parameters:

- permanent light mode without the influence of the PIR sensor for 60 minutes: it can be set with the remote control by pressing the button ON (max. power) or MODE3 (half power) or by repeatedly pressing the control button directly on the light body. In this mode, the lamp will be lit continuously for 60 minutes without the influence of the PIR motion sensor and at the same time blocked by ambient light. Consumption from the Li-ion battery in this mode is 1.5A – full power or 0.42A – half power.
- light activation mode during movement – the PIR sensor is active: it can be set to MODE1 with the remote control or by repeatedly pressing the control button on the light body. In this mode, the lamp will shine at maximum power only when activated by the PIR sensor for 30 seconds, and at the same time this function will be blocked by ambient light. Consumption from the Li-ion battery in this mode is 1.5A when the light is on
- permanent light mode with activation of maximum brightness by PIR sensor: can be set to MODE2 with the remote control or by repeatedly pressing the control button directly on the light body. In this mode, the light will be permanently on with minimum power and the maximum light will be activated by the PIR sensor for 30 seconds. The overall lighting is blocked by ambient light. Consumption from the Li-ion battery is 0.04A continuously and 1.5A when activated by the PIR sensor.


Technical parameters:

- light source – LED COB, a total of 8× panels of 20 LEDs each
- luminous flux: 500lm at maximum power
- PIR sensor: 120°, sensitivity 3m
- remote control: IR, 6 buttons
- power supply: 1× Li-ion cell 18650
- charging: solar cell 65×95mm 5V / 6W
- charging time: 8h in full sunlight
- the operating time depends on the operating mode. With continuous light at full power, the battery will last about 2 hours, with occasional use with a PIR sensor, even several days without charging.
- dimensions: 270×145×30mm, holder length 140mm
- weight: 500g

Warning: the cells used may be in an uncharged state. Before first use, leave in direct sunlight for several hours or disassemble (6 screws), remove cells and charge separately. When using high-quality cells with a capacity of 2500 mAH, the operating time will be proportionally extended.