Tipa

Waterproof and dustproof charger with built-in Bluetooth technology, allowing you to display information from your charger to your smartphone, tablet or computer. Optimal for batteries with a capacity of 50-130Ah.

- Built-in Bluetooth technology for setting, displaying voltage and current
- Dust, water and chemical resistance
- Intelligent seven-stage charging algorithm
- Recovery of a completely discharged "dead" battery
- Automatic power supply function
- Resistant to low temperatures down to -30°C
- Several other functions to increase battery life
- Low power mode for charging small batteries
- Special mode for charging Li-ion batteries
- 5-year warranty

Bluetooth
You can set, display and configure the Blue Smart IP65 charger via your smartphone. You can view the status of the charger and battery. Even control the charger functions using the VictronConnect app. The default voltage and current value is displayed on the screen. You can download the app for iOS and Android here. You can also download the VictronConnect app for free from Google Play or the App Store. This app is not yet available for Windows mobile phones.

View the detailed online manual with a description of all Smart functions here.

Regeneration
A lead-acid battery that has already been undercharged or left discharged for several days or weeks will deteriorate due to sulphation. If detected early, sulphation can sometimes be partially reversed by charging with a low current until the battery reaches a higher voltage.

Recovery function for completely discharged batteries
Most chargers with reverse polarity protection do not recognize batteries that have been discharged to zero or almost zero voltage and therefore will not start charging them. However, the Blue Power Charger will attempt to recharge even a completely discharged battery with a low current and resume normal charging as soon as sufficient voltage appears at the battery terminals.

Ultra-high efficiency “green” battery charger
With an efficiency of up to 95%, these chargers produce up to 4x less heat than the industry standard. When the battery is fully charged, the power consumption is reduced to 0.5W, which is 5x to 10x better than the current standard.

Long life, safety and quiet operation
-Low thermal load on electronic components.
-Protection against dust, water and chemicals.
-Overheating protection: the output current will decrease with increasing temperature up to 60°C, but the charger will not fail.
-The chargers are completely silent: they do not contain an active heat sink (fan) or other moving parts.

Storage mode: less corrosion of the positive electrodes
Even the lower float charge voltage that follows the absorption phase can cause grid corrosion. It is therefore essential to continue to reduce the charging voltage if the battery remains connected to the charger for more than 48 hours.

Temperature compensated charging
The optimal charging voltage for a lead-acid battery varies inversely with its temperature. The Blue Power IP65 Charger measures the ambient temperature during the test phase and compensates for it during charging. The temperature is measured again when the charger is in low current mode during maintenance or storage. Therefore, no special settings are required for cold or hot environments.

Charging mode for Li-ion batteries
The Blue Power Charger uses a special charging algorithm for Li-ion (LiFePO4) batteries, with automatic reset of the undervoltage protection for Li-ion batteries.

Normal charging voltage mode 28.8V - suitable for gel and AGM batteries. High charging voltage mode 29.4V - suitable for open flooded batteries.

Technical parameters:

Input voltage: 180 – 265 V alternating voltage (AC)
Frequency: 45 – 65 Hz
Charging current: 13 A
No-load power consumption: 0.5 W
Absorption charging voltage: 28.8 V
Float charging voltage: 27.6 V
Storage mode voltage: 26.4 V
Protections: output polarity reversal, output short circuit, overheating
Operating temperature range: from – 30 to + 50 °C
Humidity: maximum 95%
Battery output: black and red cable, 1.5 m long
230 V AC charger input: 1.5 m cable with classic plug
Protection level: IP 65
Plug type: CEE7/7 (Schuko)
Weight: 1.9 kg
Dimensions (height x width x length): : 75 x 140 x 240mm