Tipa

Water and dust resistant charger with built-in Bluetooth technology, allowing you to display information from your charger to your smartphone, tablet or computer. Optimal for batteries with a capacity of 100-265Ah.

Built-in Bluetooth technology for setting, displaying voltage and current
Resistant to dust, water and chemicals
Intelligent seven-stage charging algorithm
Recovery of a completely discharged "dead" battery
Automatic power function
Resistant to low temperatures down to -30°C
Several other functions increasing battery life
Low power mode for charging small batteries
Special mode for charging Li-ion batteries

Bluetooth
You can set, display and configure the Blue Smart IP65 charger via your smartphone. You can view the status of the charger and battery. Even control the charger functions using the VictronConnect app. The default voltage and current value is displayed on the screen. You can also download the VictronConnect app for free from Google Play or the App Store.

Regeneration
A lead acid battery that has already been undercharged or left discharged for several days or weeks will deteriorate due to sulphation. If detected early, sulphation can sometimes be partially reversed by charging at a low current until the battery reaches a higher voltage.

Recovery function for deeply discharged batteries
Most reverse polarity protected chargers will not recognise batteries discharged to zero or near zero voltage and will therefore not start charging them. However, the Blue Power Charger will attempt to recharge even a deeply discharged battery at a low current, restoring normal charging as soon as sufficient voltage is present at the battery terminals.

Ultra-high efficiency “green” battery charger
With efficiencies of up to 95%, these chargers produce up to 4x less heat than the industry standard. When the battery is fully charged, the power consumption is reduced to 0.5 W, which is 5 to 10 times better than the standard.

Long life, safety and quiet operation
Low thermal load on electronic components.
Protection against dust, water and chemicals.
Overheating protection: the output current will decrease with increasing temperature up to 60°C, but the charger will not fail.
The chargers are completely silent: they do not contain an active heat sink (fan) or other moving parts.

Storage mode: less corrosion of the positive electrodes
Even a lower float charge voltage that follows the absorption phase can cause grid corrosion. It is therefore essential to continue to reduce the charging voltage if the battery remains connected to the charger for more than 48 hours.

Temperature compensated charging
The optimal charging voltage for a lead-acid battery varies inversely to its temperature. The Blue Power IP65 Charger measures the ambient temperature during the test phase and compensates for it during charging. The temperature is measured again when the charger is in low current mode during maintenance or storage. Therefore, no special settings are needed for cold or hot environments.

Charging mode for Li-ion batteries
The Blue Power Charger uses a special charging algorithm for Li-ion (LiFePO4) batteries, with automatic reset of the undervoltage protection for Li-ion batteries.

Normal charging voltage mode 14.4V - suitable for gel and AGM batteries. High charging voltage mode 14.7V - suitable for open flooded batteries.

Technical parameters:

Input voltage: 180 – 265 V alternating voltage (AC)
Frequency: 45 – 65 Hz
Charging current: 25 A
No-load power consumption: 0.5 W
Absorption charging voltage: 14.4 V
Float charging voltage: 13.8 V
Storage mode voltage: 13.2 V
Protections: output polarity reversal, output short circuit, overheating
Operating temperature range: from – 30 to + 50 °C
Humidity: maximum 95%
Battery output: black and red cable, 1.5 m long
230 V AC charger input: 1.5 m cable with classic plug
Protection level: IP 65
Plug type: CEE7/7 (Schuko)
Weight: 0.9 kg
Dimensions (height x width x length): 75 x 140 x 240 mm