Due to the amendment of the VAT legislation under the EU Directive, all foreign sales to end/ retail customers are currently suspended. B2B transactions remain unchanged.
WALL RECOVERY FI 125MM VENT SOLO PLUS WITH REMOTE CONTROL
Effective, energy-saving permanent ventilation of individual rooms while simultaneously minimizing heat loss. Filtration of the supplied air. Support for maintaining the correct air humidity. For installation directly in the external wall.
Technical parameters: Running: I / II Power [W]: 0.7 / 2.3 current [A]: 0.020 / 0.034 Performance in wind mode [m3/h]: 25 / 50 Performance in heat recovery mode [m3/h]: 7 / 14 Noise level [dB(A)/~3m]: 16 / 29 Heat recovery efficiency: up to 85% Degree of protection: IP24
Phase I (60 seconds) - Exhaust air from the room The warm, used air removed from the room passes through the heat exchanger and transfers the heat and humidity. After 60 seconds of heat exchanger heating, the ventilation unit switches to air supply mode.
Phase II (60 seconds) - Air supply to the room Fresh, cool air from outside passes through the heat exchanger. The air is humidified and heated by the heat accumulated earlier in the exchanger. After 60 seconds, the fan switches to extraction mode again and repeats the cycle.
Remote control - operating modes: Choice of run Turning on the humidity sensor Night mode
Humidity sensor: The operation of the device can be controlled using a sensor humidity. Using the enclosed plastic the screwdriver must be set to the desired potentiometer humidity level in the range of 60-90%. If moisture in the room exceeds the set value, device automatically turns on and works until moisture will return to normal.
Installation: The device is intended for internal installation in a through hole in the outer wall of the building.
Cash on delivery 
cash 
Online 
bank transfer 
Nobody has entered comment on this product yet. Be first!