Tipa

Designed to reduce the pH value of pool water. The ideal pH value of bathing water should be in the range of 6.8 – 7.6. In this range, disinfectants work with maximum efficiency and without negative side effects.

Instructions
Slowly pour the required amount of product (dissolved in water in a plastic container) into the pool at the water inlet with the filter device switched on. Check the pH value (testers) only after complete mixing. Repeat this process until the pH is in the desired range. It is necessary to exclude the presence of people in the pool until the preparation has been perfectly mixed by the filter device! Then check the pH value once a week and regulate any detected deviations from the ideal value by adding Cranit pH plus or Cranit pH minus. Inspection is necessary especially before adding disinfectants.

Dosage
15 g of product (1 level tablespoon) per 1 m3 of water (1,000 liters) will reduce the pH value by approximately 0.2 (a higher dose is usually required for hard water).

Hazard identification
Signal word: DANGER

H318 Causes serious eye damage.

P101 If medical attention is needed, have product container or label at hand.
P102 Keep out of reach of children.
P501 Dispose of contents/container to hazardous waste!
P280 Wear protective gloves/protective clothing/safety glasses/face shield.
P305+P351+P338 IF IN EYES: Rinse cautiously with water for several minutes. Remove contact lenses, if worn and if they can be removed easily. Continue rinsing.
P310 Immediately call a TOXICOLOGICAL INFORMATION CENTER or a doctor at 224919293, 224915402.