Due to the amendment of the VAT legislation under the EU Directive, all foreign sales to end/ retail customers are currently suspended. B2B transactions remain unchanged.
We do not have the goods in stock at the moment, but we will order additional pieces from our supplier. We recommend setting a watchdog alert for back in stock info
An extremely innovative product that does not require any assembly work, discreet, unobtrusive yet works perfectly. You do not need to drill the bumper for installation, as with classic ultrasonic reversing radars. By filling the space that is generated by the open ring of vibrations behind the car, much like a retractable radio antenna. If any object enters this field, the indoor unit will start beeping and the display will also signal an approaching object. The reversing tape has a strong self-adhesive layer that is not thermally soluble. , it is necessary to attach the tape to the inner edge of the bumper and connect it to the inner control unit. Power is taken from the reversing lamp bulb, so the sensor is only activated during reversing. If you are unsure about the installation, consult a professional.
- Innovative, electromagnetic principle - No need to drill the bumper - There is no dead angle due to belt continuity - Simple installation - Compatible with any car - Can be cut to the required length - You can install it on the front and side of the vehicle as needed - Loud signaling of an approaching object (beep, thick beep, continuous beep)
Installation: If you need better access, remove the bumper! Clean and degrease the inside of the bumper Apply the non-adhesive tape to the bumper, then cut it to the required size. In order to avoid blind spots, you can also stick the tape on the side wall of the bumper. Stick the tape on a flat surface, make sure it is not wrinkled, flatten it. If your car has a towing hook, the belt must be placed higher so that the hook does not fit into the angle of the belt. ATTENTION! You can remove the tape after it has been applied, but it cannot be applied again. Connect the control unit to the tape connector and place it in a place where water cannot reach it. Provide power to the device from the reversing bulb. Make sure the connectors are properly insulated! Place the speaker in the desired position (under the back seat, in the luggage compartment), attach the accessories using double-sided adhesive tape. Enter reverse and ask someone for help during testing.
Technical parameters:
- Power supply: 12 V - Belt length: 220 cm - Detection distance: approximately 60 - 70 cm - Detection technology: Electromagnetic
Cash on delivery 
cash 
Online 
bank transfer 
Nobody has entered comment on this product yet. Be first!