Tipa

Discounted set: 5m LED strip 12V 3527 60LED/m IP20 4,8W/m CCT, variable (W+N+C) + power supply 12V DC + CCT controller + connecting CCT connector.

This kit is ready for a quick installation in the desired place, just connect the individual parts and plug it into a socket.

CCT LED strips allow you to set any tone of white, from warm to neutral to cold (from 2700 to 6500 Kelvin)
This setting is possible thanks to the construction of the LED strip on which two LED chips are placed side by side, each one in warm white and the other in cold white colour.

Smooth adjustment of the desired light temperature is only possible with the help of a controller, which can also turn the LED strip on, off or dim it. The controller must be ordered separately and can be found in the "Accessories" section.

There is no limit for creativity or imagination, when it comes to the usage of LED strips. You can use them to illuminate staircases, work desks, kitchen cabinets, wardrobes, or to illuminate different corners of your house or apartment etc.

Technical parameters:

- power supply: 12V DC
- chip type: 3527
- number of LED: 60/m
- consumption: max. 4,8 W/m
- colour: CCT (2700-6500 K)
- luminous flux: 7-8 lm/LED
- CRI: >80
- beam angle: 120°
- protection: IP20 (not waterproof)
- dimensions: 8 mm x 5 m
- operating temperature: -25° až 85° C
- double-sided self-adhesive 3M tape on the back - before application the surface must be cleaned of dirt and degreased

Power supply:

- input voltage: 240V AC – 50/60 Hz
- output voltage: 12V DC
- output current: 2500 mA
- connector DC: 2,1 x 5,5 mm
- protection:

IR Receiver + remote LED strip controller

- supply voltage: 12-24V DC
- output current: < 6A
- operating temperature: -20°C to +60°C
- connector DC: 2,1 x 5,5 mm
- dimensions IR reciver : 61 x 35 x 22mm
- weight: 24g
- dimensions IR remote control: 52x85x7mm
- power supply IR remote control: 3V bat. CR2025


- price is for a set: LED strip 5m + power supply 12V DC + CCT kontroller + connecting CCT connector.

Due to cooling, it is recommended to install the LED strip lights into aluminum profiles. Application to other surfaces may cause overheating and damage to the strips and may be considered as damage caused by improper use.