Tipa

Discounted set: 2,5m LED strip 24V 5050 60LED/m IP20 12W/m RGB + power supply 24V DC + RGB RF controller + connecting RGB connector.

This kit is ready for a quick installation in the desired place, just connect the individual parts and plug it into a socket.

LED strip lights are advanced option for interior and exterior lighting. They can be used as a decorative lighting, edge lighting of stairs, wall corners, handrails, illumination of shelves, showcases or shop windows. They have a low power consumption. LED strips are powered by a 12V or 24V power supplies. They can be cut into individual modules (6 LEDs) and linked by connectors or by soldering cables to the given points (before soldering it is necessary to clean the surfaces). The enclosed RGB controller can remotely switch the LED strip on / off, change or fade colours and flashing speed. Thanks to RF transmission, the remote controller does not have to have direct visibility of the receiver, as in case of IR transmissions. The receiver can therefore be placed behind a cabinet, television set or under the bed.

Technical parameters:

- power supply: 24V DC
- chip type: 5050
- number of LED: 60/m
- consumption: max. 12 W/m
- colour: RGB
- luminous flux: 14 lm/LED
- beam angle: 120°
- protection: IP20 (not waterproof)
- dimensions: 10 mm x 2,5 m
- operating temperature: -25° až 85° C
- double-sided self-adhesive 3M tape on the back - before application the surface must be cleaned of dirt and degreased
- length of cable on both sides approx. 10 cm (without connectors)

Power supply:

- input voltage: 110–240V AC – 50/60 Hz
- output voltage: 24V DC
- output current: 2500 mA
- power consumption: 60 W
- connector DC 2,1 x 5,5 mm
- protection: IP44

RF Receiver + remote LED strip controller:

- supply voltage: 12-24V DC
- output current: max. 3 x 4 A
- operating temperature: -20°C až +60°C
- connector DC: 2,1 x 5,5 mm
- dimensions receiver: 60 x 15 mm
- remote frequency: 433,92 MHz
- power supply RF remote control: 3V bat. CR2025
- remote distance: cca 30 m at open area
- dimensions RF remote control: 87 x 41 x 7 mm

- pice is for a set: LED strip 2,5m + power supply 24V DC + RF RGB controller + connecting RGB connector.

Due to cooling, it is recommended to install the LED strip lights into aluminum profiles. Application to other surfaces may cause overheating and damage to the strips and may be considered as damage caused by improper use.