Tipa

Discounted set: 1m LED strip 12V 5630 120LED/m IP65 24W/m natural white + RF controller + power supply 12V DC + DC connector

This kit is ready for a quick installation in the desired place, just connect the individual parts and plug it into a socket.

LED strip lights are advanced option for interior and exterior lighting. They can be used as a decorative lighting, edge lighting of stairs, wall corners, handrails, illumination of shelves, showcases or shop windows. They have a low power consumption. LED strips are powered by a 12V or 24V power supplies. They can be cut into individual modules (3 LEDs) and linked by connectors or by soldering cables to the given points (before soldering it is necessary to clean the surfaces). The enclosed controller can remotely switch the LED strip on / off, dimming and flashing speed. Thanks to RF transmission, the remote controller does not have to have direct visibility of the receiver, as in case of IR transmissions. The receiver can therefore be placed behind a cabinet, television set or under the bed.

Technical parameters:

- power supply: 12V DC
- chip type: 5630 SANAN
- number of LED: 120/m
- consumption: max. 24 W/m
- colour: neutral white (4000-4500 K)
- luminous flux: 20 lm/LED
- beam angle: 120°
- protection: IP65
- dimensions: 10 mm x 1 m
- operating temperature: -25° až 85° C
- double-sided self-adhesive 3M tape on the back - before application the surface must be cleaned of dirt and degreased

Power supply:

- input voltage: 240V AC – 50/60 Hz
- output voltage: 12V DC
- output current: 2500 mA
- connector DC 2,1 x 5,5 mm

RF Receiver + remote LED strip controller:

- supply voltage: 5-24V DC
- output current: max. 6 A
- power consumption: max. 5V<30W / 12V<72W / 24V<144W
- operating temperature: -20°C až +60°C
- connector DC: 2,1 x 5,5 mm
- dimensions receiver: 70 x 15 mm
- remote frequency: 433,92 MHz
- power supply RF remote control: 3V bat. CR2025
- remote distance: cca 15 m at open area
- dimensions RF remote control: 87 x 41 x 7 mm

- pice is for a set: LED strip 1m + power supply 12V DC + RF controller + DC connector.

Due to cooling, it is recommended to install the LED strip lights into aluminum profiles. Application to other surfaces may cause overheating and damage to the strips and may be considered as damage caused by improper use.