Tipa

LED diode strips are a modern variantion of interior and exterior lighting. They can be used to illuminate buildings, garden gazebos, furniture, staircases, advertising areas, showcases, shop windows etc. They have low power consumption and long life span. These LED strips are powered by 230 V and it is therefore necessary to obide all principles of safety while working with live electrical devices! A 230 V DC connection is required, so it is necessary to use the original power cord, which is only part of the entire reel. If you buy the strips in cut meters it is necessary to buy this cable separately. You can find it in the "Accessories" section. The LED strip can be cut into 1 m length only at the marked places. The strips can also be joined together with the corresponding connectors.

Important notification:
230V LED strips do not need to be installed in Al profiles. Up to 100 m LED strips can be connected to one power cable. Before installing the LED strip, carefully check that it is not mechanically damaged and read the enclosed instructions. Always check that the end of the strips are covered with a protective cap! To maintain IP67 protection, all connections and fittings must be sealed with silicone sealant No. 06560235. Have the installation carried out by a qualified person. In case of non-compliance with the installation instructions, claims will not be accepted

Technical parameters:

- power supply: 230V AC
- chip type: 3528
- number of LED: 60/m
- consumption: max. 4,8 W/m
- color: red (620-625 nm)
- luminous flux: 6-7 lm/LED
- beam angle: 120°
- protection: IP67
- dimensions: 10,5 mm x 1 m
- operating temperature: -25° to 85° C
- price is for 1 m of LED strip