Tipa

Carbon monoxide detector - Measuring equipment - Model Kidde 7CO
A new hi-tech solution from the category of carbon monoxide detectors with the first second-generation electrochemical sensor and a de-ionized water electrolyte, which performs testing every second for the fatal danger in the form of carbon monoxide (CO) and enables continuous monitoring of CO levels.

The first CO detector with a conformal nanowax layer protecting the electronics of the device even in very humid environments.

The device is thus suitable for placement or installation, for example, in bathrooms with karma, gas boilers, boiler rooms and the like.

The device performs repeated measurements every second. Exceeding the maximum CO level is visually indicated (by a red LED) and by an acoustic alarm (loudly pulsating with a signal strength of 85 dB).

The carbon monoxide measuring device is equipped with Test / Reset buttons, which are able to verify the correct operation of the device. The condition of the sensor, batteries and internal circuits is monitored by the automatic efficiency control system. If a fault is detected, the corresponding safety signal is triggered. Battery power allows the device to be placed in the optimal position. Thanks to the special construction of the device, it is possible to place it not only on the wall in the room but also on flat surfaces, such as a bedside table.

Carbon monoxide is a colorless, tasteless and odorless gas produced by the poor combustion of fossil fuels such as coal, oil, natural gas, LPG, coal and wood. It can also be produced by poorly maintained or broken fuel burning appliances intended for domestic heating, such as: boilers, gas appliances, karma, grills, clogged chimneys, ventilation systems or damaged flue pipes.

Common symptoms of CO poisoning include headaches, nausea, fatigue, or muscle aches - but these can be easily confused with the diagnosis of flu. It is therefore important to protect your family and home with carbon monoxide detectors.

- Kidde Electrochemical Technology - second generation sensors - with de-ionized aqueous electrolyte that performs testing every second
- Nanowax layer protecting the electronics of the device against moisture
- 100% longer service life compared to older models
- Twice the size of older models
- 85dB loud alarm
- Test / Reset function - verifying the correct operation of the device
- Battery powered
- Installation on a wall or on a flat surface
- Signaling the end of equipment life
- Low operating costs, small size and weight
- Easy installation and handling
- Timeless and modern design
- 10 year warranty

The carbon monoxide measuring device has a certificate confirming compliance with the requirements of the Czech technical standard ČSN-EN 50291: 2010 for domestic carbon monoxide detectors. Compliance with this standard has been confirmed by an independent research laboratory of the British Standard Institute (BSI).

Technical parameters:

- Sensor technology: Kidde electrochemical technology - patent, one of the most accurate technologies in the world.
- Power supply: DC, three 1.5 V AA alkaline batteries (included).
- Mounting method: On a wall (screws included) or on a flat surface.
- Signaling
- Exceeding the permissible CO concentration: Acoustic alarm 85 dB and visual (red LED).
- End of life notification: Two beeps and two red LEDs flash within 30 seconds.
- Low battery indication: Beep together with red and green LED indication.
- Test / Reset function: Button for checking, maintaining the device. After pressing it, the control unit performs a device test.
- Working temperature: +0 ° C - 40 ° C
- Operating humidity: up to 90% relative humidity (RH) non-condensing.
- Storage conditions: Temperature: -10 ° C - +60 ° C Humidity: 5% - 95% RH
- Dimensions: 127 x 72 x 35 mm
- Weight with batteries: 0.120 kg
- Approval: ČSN-EN50291: 2010part 1 household and part 2 (ships and trailers)
- Marks: CE