Tipa

The 6V/12V 15A A86 rectifier is the first battery charger on the market with a microprocessor control system using PWM technology with the ability to charge batteries up to 6V and 12V and the ability to choose non-standard battery voltage types. Thanks to the intelligent setting of the parameters, it enables the regeneration of a discharged battery.

Automatic charger designed for charging 6V and 12V lead VRLA car batteries (AGM and GEL).
Continuous system test and charging switching in 4 modes (Constant Voltage; Constant Current; Trickle Charge Modulation; Floating Charge Modulation) regenerating the battery.
Multi-stage battery protection through the use of an advanced microcomputer control system.
Pulse Width Modulation (PWM) technology enables automatic battery charging in 4 steps of the charging cycle.
Guarantee that the battery will not be damaged even in case of battery sulphation, lack of gas or loss of electrolyte.
Intelligent operating modes

Constant Voltage : Using a constant voltage to charge the battery, checking that the charging current is not too high and reducing it during the process.
Constant current : Indicates that the battery voltage is lower than the voltage set by the charger, but the charger will maintain a constant battery charging current.
Trickle charge modulation: When the battery voltage is close to the set voltage and the charging current is low to the set current, it will switch to floating charge modulation mode. This means that the battery is charged, but is constantly checked for voltage drop and automatically recharges with alternating current.
Floating Charge Modulation : The mode will keep the battery fully charged.
Protective functions

Overheat protection: When the charger temperature exceeds 150°C, the charger will stop charging. When the temperature drops to 80°C or the charger is turned off for about 10 minutes, the battery can be recharged.
Short Circuit Protection: When a circuit is short circuited, operation will automatically stop. This will be signaled by a long beep. Then carefully plug it in to start auto charging again.
Protection against reverse connection: If the terminals ( +/- ) are accidentally connected in reverse, the charger signals this with an intermittent long beep. Once the terminals are connected correctly, charging will take place again.
Charging process

The charger's charging process is based on a pulse charging system - charging for 5 seconds, then interrupting charging for 1 second will cause most of the oxygen generated during charging to become electrolyte. This method not only reduces gas formation, but the rectifier can also repair a sulfated battery.
When the charge indicator shows 25%, 50%, 75%, 100%, it shows the battery percentage:
Blinking - when the battery capacity is too low, the charger warns of too low voltage on the display by flashing. Once the charger has repaired the battery, it will display the normal charge level again.
Beep – When the battery is fully charged, a cyclical beep will sound every minute.
When you start the charger, it switches to smart charging mode by default. Every time you charge, this product scans and tests the battery. During the battery test, the battery will be displayed on the screen. After a while, the rectifier goes into mode (repair, maintenance or maintenance).

Technical parameters:

Charging current: 0-15A
Input voltage: 110VAC-250VAC
Output voltage: 6V/12V
Maximum output power: 250W
Output voltage frequency: 50/60 Hz
Charging voltage: 6V(2±7.4V)12V(8V±14.5V)
Ambient temperature: -30°C to +50°C
Protection class: IP 20
Dimensions: 17.5 x 13.5 x 7.5 cm
Weight: 0.95 kg